| Tensile Strength |
125 Min MPa |
The tensile value shown relates to tubes with a nominal outside diameter up to and including 75mm. The value for over 75mm shall be 110 N/mm2.
Tubes shall be subjected to a single drifting test, a bore test and a hydraulic test according to the formula shown in the specification.
Applications:
Drawn Tube
Characteristic Properties:
Very good atmospheric corrosion resistance and workability. High thermal conductivity and reflectivity but lower than for 1050A. Very good weldability. Slightly higher strength than 1050A.
Alloy Designations
Aluminium alloy 3L54 - 1200 is covered by Standard BS EN 4L54 (1986)
Temper Types
The most common tempers for 3L54 - 1200 aluminium is cold drawn
This Data is indicative only and must not be seen as a substitute for the full specification from which it is drawn. In particular, the mechanical property requirements vary widely with temper, product and product dimensions. The information is based on our present knowledge and is given in good faith. However, no liability will be accepted by the Company is respect of any action taken by any third party in reliance thereon.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose.
Any advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. Any contract between the Company and a customer will be subject to the Company’s Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.